GADS-PKG001 = GADS001 + GADSLTTD
The GADS-PKG001 is a combination package of 2 different GADS products put together at a discounted price sent in a single box. As a package, they work as a set to deliver a better, more comfortable riding experience at a lower overall price.
Installation Instructions View Colors
Installation Instructions
GADS001
2004 -2013 RoadGlide
GADS are created using virtually indestructible polycarbonate. GADS have a mounting system that uses the turn signal mounts to hold the deflector in place. They sit between the mounting bracket and the inner fairing, virtually invisible from the outside of the fairing. The top of the mounting flange has a hole and a notch, allowing for adjustment. The top of the flange is horizontal and sits toward the center line of the motorcycle. The notch is for the rear bolt and the wiring. Keep the wiring in the notch, do not pinch the wiring. The hole is for the front mounting stud.
- Remove protective film from GADS.
- Cover the front fender with a towel to avoid scratches or dings.
- Pick a side to install the GADS on, then remove the nuts that hold the front turn signal on but do not remove the signal yet as there are wires that power the signal.
- Pull the turn signal studs loose from the fairing but do not pull the wires out of the fairing.
- Slide the hole in the front of the deflector mounting flange between the mounting bracket and the inner fairing aligning the three holes. (inner fairing, GADS, fairing support bracket)
- Loosely install turn signal CAUTION: DO NOT PINCH WIRING
- The notch allows for a small amount of adjustment, pivot the deflectors toward the crash bar, recheck wiring, then tighten to torque spec. do not over tighten if installing GADS002 in front of lowers, install so the ploycarbonate cannot come into contact with the paint. GADS will bend a small amount under a wind load.
- Move to the other side and repeat
GADS is a small cottage industry
Thank you for your support
Made in the U.S.A.
GADS LTTD
GADS Lower Triple Tree Deflector
This deflector installs to most touring platform H-D motorcycles through 2013
If you look at the back edge of your lower triple tree and see 3 little plastic plugs or holes this is where your deflector mounts
The bolts that hold the the GADSLTTD on are 1/4”X20 tpi. The triple tree is pre-drilled and tapped to accept the included bolts.
If there is any resistance when screwing in the bolts you need to chase the threads with a 1/4”-20 tap to remove any obstruction on the threads (paint,rust,etc.)
GADS is a small cottage industry
Thank you for your support
Made in the U.S.A.
Color Choices
